|
FEATURES
- Sends On/Off and Dim/Bright commands
- Can control up to a maximum of 4 addresses
- Can only be used with pulse switches
- Two-way X-10 communication
- Status can be requested after commandshave been sent
- Enhanced reliability X-10 communication
- LED indication
PRODUCT DESCRIPTION
To operate the (switching/dimming) actuators that have been fitted, interfaces are required. When desired, each switching actuator can be controlled by more than one interface. This can be easily accomplished without having to alter the wiring. All that has to be done is that the correct addresses have to be set in, even when the actuator and interface are located in different groups or phases.
The TWM4 is a dimmer interface that can be mounted in a junction box located behind pulse switches. By applying the TWM4, lighting points provided with a dimming actuator can be dimmed and/or switched locally or by remote control.
The wires of the TWM4 module can be connected to potential-free pulse switches. With one module, a maximum of 4 addresses can be controlled by, for instance, connecting it to two 2-way pulse switches or four 1-way pulse switches. TECHNICAL DATA
- Power Supply: 230 V +10% -15% / 50 Hz
- Supply current : < 30 mA capacitive
- Signal transmission > 5 Vpp in 5O Ω at 120 kHz
- X10 transmission 1 pulse burst at 0° and 180°
- Signal sensitivity: 25 mVpp min. 6 Vpp max. at 120 kHz
- Signal to Noise ratio 1,35 : 1
- Connections: screw type terminals or phase, neutral, wire for switch connection
- Ambient temperature: -10° C to 40°C (operation)
- Dimensions: 46 x 46 x 16 mm
- Junction box must be at least 40 mm deep
- Approvals: CE Mark
 |
