Product 2 of 12 in category X10 Receivers

Switch Appliance Mikro Module
[AW12]

Retail Price : 52,90 €
2+	51,84 €
4+	50,78 €
8+	49,72 €

[Price incl. 20% VAT]

KEY FEATURES

Small enough (46 x46 x17 mm) to fit into a wallbox behind a standard wallswitch.
One-way X-10 communication.
Works with any X10 controllers

DESCRIPTION

The AW 12 Micro Module can be mounted behind any standard wallswitch , even most designer switches.

It is an X10 receiver module that can be controlled by any X10 controller or remote control sending X-10 signals. The internal relay can also be tripped by external latched or momentary action wall switches

The unit will accept either momentary acting key or a standard wall switch with latching action. All key closures must be to live. If a momentary key is used, the relay changes state each time the key is pressed, as long as the key press lasts for less than 1.75 seconds. If a standard wall switch with latching action is used, it is assumed the keypress will last for more than 1.75 seconds. In this case the relay changes state on both the closure and release. This type of response will allow the unit to also perform 2-way control if 2 changeover latching switches are connected in series - as would be the case with 2 way switching.

The AW 12 reacts to the standard X-10 commands that are: All Units Off, All Lights On, All Lights Off from any X10 controller set to its house code regardless of unit code or alternatively individual unit control by On, Off.

House code and unit code are programmed using any X10 compatible controller. There is an E²PROM that stores the house and unit code even when the power is cut.

TECHNICAL DATA

Supply voltage: 230 V +10% -15% 50 Hz
Supply current : < 20 mA capacitive
Making capacity: 2000 W ( incandescent lamp), 3 A (motors), 16 A (resistive loads)
Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz
Input impedance: ≥180 Ω (L - N) at 120 kHz
Connections: screw type terminals for phase, neutral and switched phase, wire for switch connection
Ambient temperature: -10° C to 40°C (operation)
Dimensions: 46 x 46 x 17 mm
Approvals: CE Mark